World Library  
Flag as Inappropriate
Email this Article

Hot Standby Router Protocol

Article Id: WHEBN0000854478
Reproduction Date:

Title: Hot Standby Router Protocol  
Author: World Heritage Encyclopedia
Language: English
Subject: Cisco protocols, Multicast address, Timeline of OpenBSD, MAC address, OpenBSD
Collection: Cisco Protocols
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Hot Standby Router Protocol

In computer networking, the Hot Standby Routing Protocol (HSRP) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway, and has been described in detail in RFC 2281.

The protocol establishes a framework between network routers in order to achieve default gateway failover if the primary gateway becomes inaccessible,[1] in close association with a rapid-converging routing protocol like EIGRP or OSPF. HSRP routers send multicast Hello messages to other routers to notify them of their priorities (which router is preferred) and current status (Active or Standby).

The primary router with the highest configured priority will act as a virtual router with a pre-defined gateway IP address and will respond to the ARP / ND request from machines connected to the LAN with a virtual MAC address. If the primary router should fail, the router with the next-highest priority would take over the gateway IP address and answer ARP requests with the same MAC address, thus achieving transparent default gateway failover.

HSRP version IP Protocol Group address UDP Port Virtual MAC address range
1 IPv4 224.0.0.2 (all routers) 1985 00:00:0c:07:ac:XX
2 IPv4 224.0.0.102[2] (HSRP) 1985 00:00:0c:9f:fX:XX
IPv6 ff02::66 2029 00:05:73:a0:0X:XX

In the virtual MAC address, Xs represent the group ID in hex.

HSRP is not a routing protocol as it does not advertise IP routes or affect the routing table in any way.

HSRP has the ability to trigger a failover if one or more interfaces on the router go down. This can be useful for dual branch routers each with a single link back to the gateway. If the link of the primary router goes down, the backup router will take over the primary functionality and thus retain connectivity to the gateway.

See also

References

  1. ^ Avoiding HSRP Configuration Errors
  2. ^ HSRP Version 2 Feature Design

External links

  • Cisco: HSRP Features
  • HSRP Protocol Configuration by Szukala K.
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 



Copyright © World Library Foundation. All rights reserved. eBooks from World eBook Library are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.